§ 43.17. Maintenance, preventive maintenance, and alterations performed on U.S. aeronautical products by certain Canadian persons.
564 words·~3 min read·
/us/cfr/t14/s§ 43.17·A research copy — for the controlling text, always check the official state or federal source. Not legal advice.
(a)Definitions. For purposes of this section: Aeronautical product means any civil aircraft or airframe, aircraft engine, propeller, appliance, component, or part to be installed thereon. Canadian aeronautical product means any aeronautical product under airworthiness regulation by Transport Canada Civil Aviation. U.S. aeronautical product means any aeronautical product under airworthiness regulation by the FAA.
(b)Applicability. This section does not apply to any U.S. aeronautical products maintained or altered under any bilateral agreement made between Canada and any country other than the United States.
(c)Authorized persons.
(1)A person holding a valid Transport Canada Civil Aviation Maintenance Engineer license and appropriate ratings may, with respect to a U.S.-registered aircraft located in Canada, perform maintenance, preventive maintenance, and alterations in accordance with the requirements of paragraph
(d)of this section and approve the affected aircraft for return to service in accordance with the requirements of paragraph
(e)of this section.
(2)A Transport Canada Civil Aviation Approved Maintenance Organization
(AMO)holding appropriate ratings may, with respect to a U.S.-registered aircraft or other U.S. aeronautical products located in Canada, perform maintenance, preventive maintenance, and alterations in accordance with the requirements of paragraph
(d)of this section and approve the affected products for return to service in accordance with the requirements of paragraph
(e)of this section.
(d)Performance requirements. A person authorized in paragraph
(c)of this section may perform maintenance (including any inspection required by Sec. 91.409 of this chapter, except an annual inspection), preventive maintenance, and alterations, provided—
(1)The person performing the work is authorized by Transport Canada Civil Aviation to perform the same type of work with respect to Canadian aeronautical products;
(2)The maintenance, preventive maintenance, or alteration is performed in accordance with a Bilateral Aviation Safety Agreement between the United States and Canada and associated Maintenance Implementation Procedures that provide a level of safety equivalent to that provided by the provisions of this chapter;
(3)The maintenance, preventive maintenance, or alteration is performed such that the affected product complies with the applicable requirements of part 36 of this chapter; and
(4)The maintenance, preventive maintenance, or alteration is recorded in accordance with a Bilateral Aviation Safety Agreement between the United States and Canada and associated Maintenance Implementation Procedures that provide a level of safety equivalent to that provided by the provisions of this chapter.
(e)Approval requirements.
(1)To return an affected product to service, a person authorized in paragraph
(c)of this section must approve (certify) maintenance, preventive maintenance, and alterations performed under this section, except that an Aircraft Maintenance Engineer may not approve a major repair or major alteration.
(2)An AMO whose system of quality control for the maintenance, preventive maintenance, alteration, and inspection of aeronautical products has been approved by Transport Canada Civil Aviation, or an authorized employee performing work for such an AMO, may approve (certify) a major repair or major alteration performed under this section if the work was performed in accordance with technical data approved by the FAA.
(f)No person may operate in air commerce an aircraft, airframe, aircraft engine, propeller, or appliance on which maintenance, preventive maintenance, or alteration has been performed under this section unless it has been approved for return to service by a person authorized in this section. [Amdt. 43-33, 56 FR 57571, Nov. 12, 1991, as amended by Amdt. 43-40, 71 FR 40877, July 14, 2005]
Connections11 cite this
Citation graph
cites case law
§ 43.17
Maintenance, preventive maintenance, and alterations performed on U.S. aeronautical products by certain Canadian persons.
Fed. Reg.×11
Cites 0Cited by 11 across 1 source